28
920-087-06
ADDITIONAL ACCESSORIES
MODEL NUMBER DESCRIPTION PHOTO
PXSE
SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated
steel, 2.4" sleeve extension attached to the room side of the
sleeve to allow for the installation of a PD-Series Friedrich
PTAC in a T-Series sleeve.
PDXDA
LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP
unit and provides a transition to direct up to 35% of the total
CFM to a secondary room, either left or right of the unit. Kit
includes duct plenum with discharge grille and internal baffl e,
adapter and end cap.
PDXDE
LATERAL DUCT EXTENSION A three-foot insulated
plenum that attaches to the left or right side of the duct
adapter. The extension can be cut to length by the installer.
Maximum allowable straight extension is 15 feet.
PXCJ
CONDUIT KIT WITH JUNCTION BOX Hard wire conduit kit
with junction box for 208/230V and 265V units (subbase not
required). Kit includes a means of quick disconnect for easy
removal of the chassis. *Required for 265V installations.
PXPC
15/20/30
POWER CORD RETROFIT
Replaces LCDI power cord on
230V models when unit is used with a subbase. PXPC15 is
used with 15 amp 2.5 kW units. PXPC20 is used with 20 amp
3.4 kW units. PXPC30 is used with 30 amp 5.0 kW units.
PDXRC
REMOTE CONTROL KIT Comes with one hand-held remote
for control of the PTAC unit.
CHASSIS OPTIONS
DESIGNATOR DESCRIPTION
S
STANDARD UNIT Standard PTAC/PTHP chassis. Can be 230/208V or 265V, electric or heat pump.
PXPC30
Low
Temperature
Cool
Power
Cooler
Fan
Only
Warmer
Heat
Fan
High
Fan
To Next Page
Loading...
Need help?
General
