21
REVERSING DOOR
Reattaching the door
“T” SLOT IN
FRONT PANEL
“T” POST ON
DOOR HINGE
1 Holding the door in both hands, squarely insert
the “T” post on the back of the hinge into the “T”
slot on the front panel and lower it to align the
mounting holes.
3 Close the door and test operation of hinge, strike
and latch.
2 While supporting the door, install the upper pan
head screw fi rst and then the lower one.
Í
NOTE
Correctly installed hinge screws will press hinge fl ush
to front panel. Any gap between hinge and front panel
will cause misalignment of strike to latch.
To Next Page
Loading...
Need help?
General
