4.
CLEAN
If you use the machine for the first time, or you have not run the cleaning procedure for a
long time, it is highly recommended to run the cleaning procedure first.
Before starting the cleaning process, please check the drain pipe and make sure it is with the
cap on and hung on the back side of the machine.
Plug in the power cord, the power indicator is on: you can operate this appliance by touch
the button on panel as shown above, the main function includes: ice, clean, and light.
How to start the unit
1. Take out the water reservoir on the top, place the bottom up, open the cap, pour potable
water into water reservoir, 0.97 gallon (3.7 liters) water at most at one time. Screw the cap
on to the reservoir, and put it back on the top of the appliance again.
2. Before you put back the drawer, please make sure the water tank under the drawer is empty，
if not, unplug water drain cap to drain out water completely.
3. Put the drip tray in position.
Add water, screw the cap
and put it back.
Open the cap
Operation and display areas
USING YOUR ICE MAKER
6
To Next Page
Loading...
