USING YOUR ICE MAKER
8
When Ice Full indicator is on
The ice maker automatically stops working when 8-10 ice cubes is fully made inside and the
“Ice Full” Indicator is on.
If the ice does not take out from this ice basket for a long time, it will re-detect in each 2 hours.
It will resume to make ice immediately when the ice were took out and closed the basket
completely.
Turn off the unit
If you want to stop making ice, press the "Ice" button again and the "Ice" indicator will go
off immediately, but it will keep running for a few minutes to let the ice fall down to ice
basket. The power indicator will keep on in white color and ready for "Ice" or "Clean" or
unplug the power cord from the power supply if you are no longer in use.
How to obtain the ice cube
Before starting the ice making process, please check the drain
pipe plug hang on the back of the unit.
Press the “Ice” button, the Ice Indicator lights up in white
color, it begin to work, Press this button again, it will stop
making ice. During ice making procedure, you can see how
much ice has been stored in the ice basket through the
observation window. For the first time, or if the unit has not
been used for a long time, it is recommended to clean this unit
before you start to make ice.
While the ice-maker is on, verify water level periodically. If
water pump can’t pump out water, the ice maker will stop
automatically, and the “Add water” indicator will on in red
color. Need to pour water into the water reservoir inside.
We suggest you should press “Ice” button to turn off the unit
first, then fill water up, again press “Ice” button to restart the
unit. Allow the refrigerant liquid inside the compressor at least
3 minutes to settle before restarting.
Note: Do not use tap water, milk, coke or any other kind of
liquid.
Ice Tongs
(included)
To Next Page
Loading...
