USING YOUR ICE MAKER
8
5. Before clean procedure, please fill the drawer tank with water and check the
drainpipe behind the appliance, make sure the water drain cap has been inserted
into the drainpipe; otherwise the appliance will not work properly.
6. Press“CLEAN”button“ ”, the icon lights up, it will run cleaning procedure for
at least 20 minutes, then the icon goes out. Press this button again, it will stop
cleaning.
7. After cleaning procedure, move the appliance to the edge of the desktop, make
sure that the appliance is placed steady, place a water container under the
appliance, remove drain plug from the back, pull out the plug from the drainpipe,
water in the tank under the drawer and the evaporator will drain into the water
container, then reinsert the plug and put it back again.
8. Before we start making ice,first please fill the drawer water tank with water and
check the drainpipe behind the appliance, make sure the water drain cap has
been inserted into the drainpipe; otherwise the ppliance will not work properly.
9. Press the “ICE” button “ ”, the icon lights up, it begin to work, Press this
button again, it will stop making ice.
10. For the first time, or if the appliance has not been used for a long time, it is
recommended to clean this appliance before you start to make ice.
11. While the ice-maker is on, verify water level periodically. If water pump can’t
pump out water, the ice maker will stop automatically, and the “Add water”
indicator will on. Need to pour water into the drawer water tank, then press the
“ICE” button twice to restart ice-making.
Change water in the water reservoir every 24 hours to ensure a reasonable hygiene
level. If the unit isn’t to be used, drain all water & dry the water reservoir.
Clean
How to obtain the ice-cube
For the first time, or the clean procedure has not been running for a long time, it
is highly recommended to run this procedure at first.
To Next Page
Loading...
