2.
3.
4.
Location of Parts
Wire shelves
Adjustable legs
4
Thermostat
Door
INSTALLATION INSTRUCTIONS
1.
Before using your appliance
a.
b.
c.
d.
e.
Remove the exterior and interior packing, including the foam base and all
adhesive tape. To remove any remaining tape or glue, rub the area briskly with
your thumb. Tape or glue residue can also be easily removed by rubbing a
small amount of liquid dish soap over the adhesive with your fingers. Wipe
with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluid or abrasive
cleaners to remove tape or glue. These products can damage the surface of
your freezer.
When moving the appliance, do not tilt it more than 450 from the upright
position.
Before connecting the appliance to the power source, let it stand upright for
approximately 30 minutes. This will reduce the possibility of a malfunction in
the cooling system from handling during transportation.
Clean the interior surfaces with lukewarm water using a soft cloth.
To Next Page
Loading...
