IMPORTANT SAFETY UPDATE
Room
Air
Conditioners
manufactured
after
August
1
st
,
2004
are
equipped
with
a
new
industry
regulated
power
cord
with
either
of
the
following
in
the
plug-head
or
in
line:
LCDI:
Leakage
Current
Detection
Interrupter
AFCI:
Arc-Fault
Circuit
Interrupter.
All
Frigidaire
products
have
an
LCDI
located
in
the
plug
head
or
in-line.
The
power
supply
cord
contains
a
current
device
that
senses
damage
to
the
power
cord.
To
test
your
power
supply
cord
does
the
following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug head. Press the TEST
button. You will notice a click as the RESET button pops out.
3. Press the RESET button. Again you will notice a click as the button engages.
4. The power supply cord is now supplying electricity to the unit. (On some products
this is also indicated by a light on the plug head).
Notes:
Do not use this device to turn the unit on or off.
Always make sure the RESET button is pushed in for correct operation.
The power supply cord must be replaced if it fails to reset when either the TEST
button is pushed, or it cannot be reset. A new one can be
obtained from the product manufacturer.
If power supply cord is damaged, it CANNOT be repaired, it MUST be replaced by
one obtained from the product manufacturer.
3
To Next Page
Loading...
