Frigidaire FAC127P1A User Manual

1
Installation Instructions
READ BEFORE INSTALLING UNIT
Compact II Window Mounting
Your air conditioner is designed to install in standard
double hung windows with opening widths of 23 to 36
inches (584 mm to 914 mm) (FIG. 1)
Lower sash must open sufficiently to allow a clear vertical
opening of 14-1/2 inches (368 mm). Side louvers and the
rear of the AC must have clear air space to allow
enough airflow through the condenser, for heat removal.
The rear of the unit must be outdoors, not inside a
building or garage.
TOOLS NEEDED:
Phillips Screw Driver
Drill (If pilot holes are needed)
Qty.
3/4"screws 7
lock frame 2
sash lock 1
Mounting Hardware
When handling unit, be careful to avoid cuts
from sharp metal edges and aluminum fins on
front and rear coils.
NOTE:
SAVE CARTON and these INSTALLATION
INSTRUCTIONS for future reference. The carton is the
best way to store unit during winter, or when not in use.
Some assembly is required. Please read these instructions
carefully.
CAUTION
Fig. A
Fig. B
Fig. C
Fig. E
Fig. F
Fig. G
Fig. D
Before installing the unit, the Left-Hand
Louver must be assembled to the unit:
A. Carefully remove power supply
cord from air discharge area
(Fig. A).
B. Carefully remove the Left-Hand
Louver Assembly from the
discharge area, and then remove
it from the plastic bag(Fig. B).
C. With care, pry apart the auger
wheel shaft from the horizontal
louver casing, as shown in Fig.
C, D & E.
D. Now locate the auger wheel
shaft into the vertical center
post (Fig. F).
E. Clip the other end into the
locating slot.
F. Now place the horizontal louver
casing onto the auger wheel
shaft, and snap in place (Fig.
G).
G. Check the operation by moving
the horizontal louver up and
down, and then turn the auger wheel so the vertical
louvers rotate.
SZ000357(En) 10/21/2004, 10:42 AM1

Frigidaire FAC127P1A Specifications

General

Cooling Capacity	12, 000 BTU
Voltage	115V
Weight	75 lbs
Room Size	Up to 550 sq. ft.
Power Cord Length	6.5 ft
Filter Type	Washable
Installation Type	Window
Color	White
Type	Window
Features	Remote Control

Summary

Installation Instructions

Compact II Window Mounting

Instructions for mounting the Compact II air conditioner in standard double hung windows.

Left-Hand Louver Assembly

Procedure for assembling the left-hand louver to the air conditioner unit before installation.

Mounting Hardware

List of hardware components required for mounting the air conditioner unit.

How to Install

Prepare and Install Window Filler Panels

Steps for preparing and attaching the window filler panels to the air conditioner.

Position Unit in Window Opening

Guidance on carefully placing the air conditioner unit into the prepared window opening.

Extend Side Panels

Instructions for extending the side panels to fit against the window frame.

Secure Frame to Window Sill

Method for securing the air conditioner frame to the window sill using locking screws.

Secure Unit to Window Sash

Instructions for fastening the unit to the window sash using locking screws.

Secure Lower Sash

Procedure to secure the lower window sash in place using a right angle sash lock.

Install Foam Seal

Guidance on cutting and inserting foam seal between the upper and lower window sashes.

Handling Storm Window Obstructions

Options for managing storm window obstructions during air conditioner installation.

Removing AC From Window

Steps for Removing Unit

Detailed steps for safely disconnecting and removing the air conditioner from the window.