EasyManuals Logo

Frigidaire FDF50S1ENG11 User Manual

Frigidaire FDF50S1ENG11
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Avoid Service Checklist
Before calling for service, review this list. It may save you time and expense. This
list includes common occurrences that are not the result of defective workman-
ship or materials in this appliance.
OCCURRENCE
DEHUMIDIFIER DOES NOT OPERATE.
SOLUTION
Plug is disconnected from outlet. Push plug firmly into wall outlet.
House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit
breaker.
The dryness level you selected has been reached. Dehumidifier automatically shuts off when
selected amount of moisture has been removed from the air. If you want to remove more
moisture, Select 'CONTINUOUS' by using the humidity button or knob. After the dehumidifier starts,
reset the control to the desired setting.
Bucket not installed properly. See "Removing Collected Water."
Water in the bucket has reached its preset level. Dehumidifier automatically turns off when this
occurs. Empty bucket and return bucket to position.
Dehumidifier is not turned on. Turn unit on.
DEHUMIDIFIER RUNS TOO MUCH.
Windows or doors near dehumidifier are open to outdoors. Close all windows or doors to outside.
Area to be dehumidified is too large. Check with your dealer to see if capacity is adequate.
Air movement through dehumidifier is blocked. Grill or filter may be dirty. Use brush attachment of
vacuum cleaner to clean grill. See "Care and Cleaning." Dehumidifier must be placed in a space
that does not restrict air flowing into the rear coil or out of the front grill.
Dehumidifier has been installed or restarted recently. The higher the moistuire in the room, the
longer the dehumidifier will operate.
Dehumidifier is in the CONT mode and will remain on in this mode use the humidity
button or knob to set a RH% higher level.
DEHUMIDIFIER IS OPERATING BUT
ROOM IS NOT DRY ENOUGH.
Humidity setting is too high. Press the HUMIDITY button or rotate knob to a lower setting
or choose CONTINUOUS for maximum dryness.
Dehumidifier has been installed or restarted recently. The higher the moisture in the room air, the
longer it takes for the room air to become dry.
Dehumidifier does not have sufficient clearance to operate. Air flow to front grill is blocked. See
"Selecting a Location."
Room temperature is too low. Unit will not operate satisfactorily if the room temperature is below
41°F (5°C). See "Operating Conditions."
Refer to causes under DEHUMIDIFIER RUNS TOO MUCH.
FROST APPEARS ON COILS ABOVE
BUCKET OR DRIP TRAY.
Dehumidifier has been turned on recently. This is normal due to refrigerant rushing through the
coil. Frost will usually disappear within 60 minutes.
Room Temperature is too low. All models will operate satisfactorily at temperatures greater than
41°F (5°C).
NOISE IS LIKE A FAN.
Air is moving through the dehumidifier. This is a normal sound.
If These Solutions Fail, Call 1-800-444-4944 For Frigidaire Service.
9

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Frigidaire FDF50S1ENG11 and is the answer not in the manual?

Frigidaire FDF50S1ENG11 Specifications

General IconGeneral
BrandFrigidaire
ModelFDF50S1ENG11
CategoryDehumidifier
LanguageEnglish

Related product manuals