Frigidaire FDPC4314AW User Manual

6
CONTROLS AND SETTINGS
1
Wash Cycle Selections:
Cycle times are approximate and
will vary with options selected.
Hot water is necessary to activate
dishwasher detergent and melt fatty
food soils. An automatic sensor
will check the incoming water
temperature and, if it is not hot
enough, the cycle will be lengthened
for automatic water heating in the
main wash and final rinse of all
cycles. This happens even when
High temp wash option has not been
selected. When High temp wash is
selected, an even higher temperature
will be reached to handle heavier soil
loads.
2
Temp
The programmed cycles default to
the Normal cycle option, to choose
Sanitize or High, press the Temp pad.
Sanitize Option
To sanitize your dishes and
glassware, select Sanitize option.
When selected, the light will come
on and remain on until end of cycle.
The water temperature in the final
rinse will be raised to 155
o
F (68
o
C)
and will maintain that temperature
for 9 minutes. This option is available
in Heavy and Normal Cycles. Only
these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended
until the proper water temperature
is reached. Washing action will
continue during the water heating
delay. For best results, the incoming
water temperature should be at least
120
o
F (49
o
C).
The sanitize criteria may not be
satisfied if there is an interruption
of the cycle, power failure or if the
incoming water temperature is
below 120
o
F (49
o
C).
To turn o the Sanitize option, press
the Temp pad a second time. The
light beside the Sanitize pad will
turn o.
CAUTION
Property Damage Hazard
Before starting dishwasher be sure that
the water is connected and turned on.
Failure to do so may cause damage
to the pump seal and result in water
leakage.
Option Selections

NOTE
Your dishwasher uses a DishSense
TM
Technology to understand how much
food is on the dishes and then adjusts
the cycle accordingly.
Recommended Cycle for typical
use:
The Normal cycle with its factory default
options of normal temperature and
heated dry together provide the best all
around performance. This cycle selection
is recommended for everyday use and
is suitable for a large range of both dish
load sizes and food quantities remaining
on those dishes.
4 5 61
NOTE
The dishwasher is programmed to
remember your last cycle so you do not
have to reset each time. To start the
dishwasher using the same cycle and
options selected on the previous wash,
just press the START/CANCEL pad.

2 3

NOTE
Not all cycles and options available on
all models.

Frigidaire FDPC4314AW Specifications

General

Brand	Frigidaire
Model	FDPC4314AW
Category	Dishwasher
Language	English