8
OPERATING INSTRUCTIONS
Operating Instructions
Getting Started
1. Load Dishwasher (See Dish
Preparation).
2. Add detergent (See Filing the
Detergent Dispenser).
3. Add Rinse Aid, if needed (See Rinse
Aid).
4. Select desired Cycle (See Cycle and
Option Chart). The cycle indicator
light will glow when selected.
5. Select desired Option (See Cycle
and Option Chart). The indicator
light beside the option will glow
when selected.
6. Run hot water faucet nearest
dishwasher until water is hot. Turn
water o.
7. To start, press START/CANCEL pad.
8. Close door to latch.
Opening the door during cycle
NOTE
If the dishwasher door is opened while
the unit is running, the START/CANCEL
pad must be pressed and the door shut
immediately to return the unit to the
selected cycle and option, this must
happen within 10 minutes for the unit to
continue the cycle.
* Select the Normal and High Temp options along with a Rinse Aid agent for improved
drying performance.
If you open the door while a cycle is
running or delay is counting down, the
dishwasher will stop running.
The LEDs of selected cycle and options
are illuminated, the status window
displays the remaining cycle time. The
LED above START pad will blink to press
start.
To resume, press START pad and close
the dishwasher door immediately.
The status window displays ‘Close’ after
the START pad is pressed.
A tone will sound indicating that the
dishwasher will begin running from the
point of interruption after the door is
closed.
If the dishwasher door is kept open for
too long, or the door is closed without
pressing START pad, the running cycle or
delay countdown will be canceled.
Child Lock Controls
To prevent children from accidentally
changing the dishwasher cycle or starting
the dishwasher, lock the dishwasher
controls by pressing and holding the
Temp pad for 3 seconds while the door
is latched. An indicator light on the lock
graphic pad will illuminate when the
controls are locked and no new selections
can be made until the lock is released. To
unlock the controls, press the Temp pad,
again for 3 seconds until the indicator light
goes out.