Frigidaire FFHS2311LB

To Next Page

ICE MAKER INFORMATION

Test Cycling

Remove cover by inserting screwdriver in notch at bottom and

prying cover from housing. Use screwdriver to rotate motor gear

counterclockwise until holding switch circuit is completed. All

components of ice maker should function to complete the cycle.

Mounting

Plate

Screws

Mounting

Plate

Screw

Motor

Gear

Timing

Gear

Water Fill

Adjustment

Water Fill Volume

The water ﬁll adjustment

screw will change the

ﬁll time. One full turn is

equal to 20cc (.68 oz.).

The correct ﬁll is 102 to

130cc (3.4 to 4.3 oz.).

When a water valve is

replaced, the ﬁll volume

must be checked.

SERVICE DATA SHEET - 240389639

R134a

ICE & WATER - AUTOMATIC DEFROST

SIDE BY SIDE MODELS

IMPORTANT SAFETY NOTICE

The information provided herein is designed to assist qualiﬁed

repair personnel only. Untrained persons should not attempt to

make repairs due to the possibility of electrical shock. Disconnect

power cord before servicing.

IMPORTANT

If any green grounding wires are moved during servicing, they

must be returned to their original position and properly se-

cured.

CAUTION: All electrical parts and wiring must be

shielded from torch ﬂame. Do not allow torch to contact

insulation; it will char at 200°F and ﬂash ignite (burn) at

500°F. Excessive heat will distort the plastic liner.

NOTE: This product comes equipped with an Electronic

Defrost Control. To initiate defrost, depress the fresh food light

switch 5 times in 6 seconds (light bulb must be working). To

terminate defrost, depress the fresh food light switch 5 times

in 6 seconds.

PERFORMANCE DATA

NO LOAD AND NO DOOR OPENINGS AT MID-POINT CONTROL SETTING

Type A with Run/Start Capacitor 65ºF (18ºC) Ambient 90ºF (32ºC) Ambient

Operating Time 32 to 40% 55 to 65%

Freezer Temperature 0º to 4ºF

-18º to -16ºC

-1º to 3ºF

-18º to -16ºC

Refrigerator Temperature 34º to 39ºF

1º to 4ºC

34º to 39ºF

1º to 4ºC

Low Side Pressure (cut-in) 5 to 12 psig

34 to 83 kPa

5 to 12 psig

34 to 83 kPa

Low Side Pressure (cut-out) -2 to 2 psig

-14 to 14 kPa

-2 to 2 psig

-14 to 14 kPa

High Side Pressure

(Last 1/3 of cycle)

90 to 115 psig

621 to 793 kPa

130 to 155 psig

896 to 1069 kPa

Wattage (Last 1/3 of cycle) 120 to 150 130 to 160

Amps (Running) 1.2 to 1.5 1.2 to 1.5

Base Voltage 115 vac (127 vac max) 115 vac (127 vac max)

DEFROST SPECIFICATIONS

Cabinet Size

Thermostat Heater

Cut-In Cut-Out Watts Ohms

23’ & 26’ 25ºF

-4ºC

47ºF

8ºC

450 30

Electronic Timer - (ADC) Defrost 24 minutes every 6 to 72 hours of compressor run time

CONDENSER FAN MOTOR

Watts RPM Amps

3.1 (Energy Star - Some models) 1100 CW Opposite Shaft .03 Running

8.0 2550 CW Opposite Shaft .07 Running

ICE MAKER SPECIFICATIONS

Electrical 115 vac (127 vac max) 60 Hertz

Thermostat Opens at 48ºF (9ºC) Closes at 15ºF (-9ºC)

Heater Wattage 165

ICE MAKER PLUG CONNECTIONS

Wire Number Wire Color Connect to:

1 Green/Yellow Ground

2 Yellow Water Valve

3 Black Line

4 Lt. Blue Neutral

P O W ER

I CE MA KER

ICE MAKER

CE MAKER

ICE MAKER

WATER VALVE

LINE

T HER MAL

C UT -O UT

HO LD

S W I T C H

T HER MOS TA T

SHUT-OF F

SWIT CH

WA TER FI LL

S W I T C H

MOLD HEATER

MO L D

MO UN TI NG

PLATE

MOTOR

N EU T R AL

BLK

B LK

BL K

BLU

L T . B L U

LT. BLU

BRN

RED

GRN / YEL

RED

Y E L

YEL

P- 3

P- 1

P- 2

P- 4

Other manuals for Frigidaire FFHS2311LB

Use & Care24 pages

Need help?

Do you have a question about the Frigidaire FFHS2311LB and is the answer not in the manual?

Summary

Performance Data

Operating Conditions and Pressure Readings

Specifies performance data including operating times, temperatures, and pressure points under various ambient conditions.

Wattage, Amps, and Voltage Requirements

Details power consumption (wattage, amps) and base voltage requirements for the unit's operation.

Defrost and Motor Specifications

Defrost Specifications

Provides cut-in and cut-out temperatures for thermostat and heater, plus wattage and resistance values.

Condenser Fan Motor Details

Lists specifications for the condenser fan motor, including electrical, thermostat, heater wattage, and RPM.

Ice Maker Information and Specifications

Ice Maker Specifications and Connections

Details electrical specifications, wire numbers, wire colors, and connection points for the ice maker.

Test Cycling Procedures

Instructions on how to test cycle the ice maker by manipulating its motor gear and switches.

Water Fill Volume Adjustment

Guidance on adjusting the water fill screw and the correct fill volume for the ice maker.