INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed
exactly, a fire or explosion may result causing property
damage, personal injury or death.
FOR YOUR SAFETY:
-- Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
-- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
-- Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
• ALL RANGES
CANTIP
• INJURYTO PERSONS
COULD RESULT
• INSTALL ANTI-TIP
DEVICE PACKED WITH
RANGE
• SEE INSTALLATION
INSTRUCTIONS
RANGE
OVERALL
DIMENSIONS
2 5 3/4"
RONT
i V EW
Minimum to _I i
Wall on Either _ ._J .. L_.:t _
Side of Range
Above 36" _30" --_)
Height. ___ I I
* Note: 3" I 30" _
Clearance Minimum
with 1lOgO or 2" tl_ _;C_greater BTU Burners.
' I
36" _ o'
J
J
SIDE
VIEW
Minimum to
,, _.aome_s on Maximum Depth
18 Either Side for Cabinets
_, of Above RangeTop,
;L
Range.
_!_/_i_ '_i' _i _!ii__
C_'Clearance Below Cooking Top and at Rear of Range.
Clearances and Dimensions Provide Proper Fuel Type
1. Location--Checklocationwhere Before Proceeding: Your range is preset tooperate on natural gas only. Some
the ranae will be installed. Check models are shipped convertiblewith partsand conversioninstructionssupplied.
for proper electrical and gas Other models have a LP/Propane ConversionKitavailable through your dealer.
supply, and the stability of the
floor.
2. Dimensionsthatareshownmu_t _l_T'_'_flr_lDONOTattempttoconvertthisrangetoLP/Propanesettingswithout
be used. Given dimensions theproperLP/Propaneconversionkitprovidedwiththerangeorobtainedfromyour
provide minimum clearance, dealer. Followall instructionsprovided withthe conversionkit.
Contact surface must be solid
and level.
EspaSol - Pdginas 9-16
P/N 316259316 (0112)
1
To Next Page
Need help?
General
