Overhead Cabinet Should Not Exceed a
Maximum Depth of 13" (33 cm)
%.c,e e
Between the Top of the
Cooking Platform and the
Bottom of an Unprotected
Wood or Metal Cabinet _.A
1
24" (61 cm) Min. when Bottom
of Wood or Metal Cabinet
is Protected by Not Less
Than 1/8" (o.g cm) Flame
Netardant Millboard Covered
With Not Less Than No. 28
MGS Sheet Steel, 0.015" (0.4
mm) Stainless Steel, 0.024"
(0.6 ram) Aluminum or 0.020"
(0.5 mm) Copper.
Edge of Cutout and
"_ Nearest Combustible 10"
Surface Above 25.4 cm)
Countertop
18" G
(45.7 cm)
•J Min. From Edge of
_.Cooktop to Nearest
Combustible Wall
(Either Side of Unit).
* Letters on this figure refer to chart
on front page except for J and K.
Apl
Junction Box
2Y2"(6.4 cm) Min. From
Edge of Cutout to Front
Edge of Countertop
Location of
It is not recommended to use
drawer underneath cooktop.
Empty space is needed for
installation purpose.
Figure 2 - COUNTERTOP CUTOUT OPENING
To eliminate the risk of burns
or fire by reaching over heated surfaces,
cabinet storage space located above the
cooktop should be avoided. If cabinet
storage is provided, risk can be reduced
by installing a range hood that projects
horizontally a minimum of 5" (12.7 cm)
beyond the bottom of the cabinets.
i
30"
36"
7 1/2" (19.1cm)
7 1/2" (19.1cm)
1 1/2" (3.8cm)
2" (5.1cm)
Model and Serial Number Location
The serial plate is located under the cooktop.
When ordering parts for or making inquires about
your cooktop, always be sure to include the model
and serial numbers and a lot number or letter from the
serial plate on your cooktop.
Serial plate is located
under the burner box
of cooktop.
2
To Next Page
Loading...
