EasyManua.ls Logo

Frigidaire FGMV174KFB User Manual

Frigidaire FGMV174KFB
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
|HSTALLA'| |OH INsrRucrleNs
BEFORE YOU BEGIN
_ Save these instructions for local
inspector's use.
_ Observe all governing codes and
coordinates.
NOTE TO iNSTALLER - Be sure to leave these
instructions with the Consumer.
Read these instructions completely and carefully.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered
under the Warranty.
Please read all instructions thoroughly before installing
the Over the Range Microwave Oven. Two people are
recommended to install this product.
NOTE TO CONSUMER - Keep these instructions for
future reference.
SKILL LEVEL - Installation of this appliance requires
basic mechanical and electrical skills.
If a new electrical outlet is required, its installation should be
completed by a qualified electrician before the Microwave
Oven is installed. See 3 ELECTRICAL GROUNDING
INSTRUCTIONS on page 2.
1 MOUHTJNGSPACE
This Microwave Oven/Hood requires a mounting space on
a wall as shown in Figure 1. It is designed to be used with
standard 12" wall cabinets.
Backsplash At least 2"
cooking
snrface
66" ormore
from floor
2 WALLCONSTRUCTION
This Microwave Oven/Hood should be mounted against and
supported by a flat vertical wall. The wall must be flat for
proper installation. If the wall is not flat, use spacers to fill in
the gaps. Wall construction should be a minimum of 2"x 4"
wood studding and 3/8"or more thick dry wall or plaster/lath.
The mounting surfaces must be capable of supporting weight
of 110 pounds--the oven and contents--AND the weight of
all items which would normally be stored in the top cabinet
above the unit.
The unit should be attached to a minimum of one 2" × 4"
wail stud or two 2" x 3" wail studs.
To find the location of the studs, one of the following methods
may be used:
A. Use a stud finder, a magnetic device which locates the
nails in the stud.
B. Use a hammer to tap lightly across the mounting surface
to find a solid sound. This will indicate stud location.
The center of the stud can be located by probing the wall with
a small nail to find the edges of the stud and then placing a
mark halfway between the edges. The center of any adjacent
studs will normally be 16" or 24" to either side of this mark.
HEEDHELP?
For customers in the United States and Canada
United States: 1-800-944-9044
Canada: 1-800-265-8352
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
316495062
TINSEB221WRRZ-ELg1
PrintedinThailand
Question and Answer IconNeed help?

Do you have a question about the Frigidaire FGMV174KFB and is the answer not in the manual?

Frigidaire FGMV174KFB Specifications

General IconGeneral
TypeOver-the-Range Microwave
Capacity1.7 cu. ft.
Power1000 Watts
Control TypeElectronic
ColorBlack
TurntableYes
Child Safety LockYes
Voltage120V
Ventilation300 CFM
Cooking ModesDefrost, Reheat
Dimensions (WxHxD)29.88" x 16.5" x 15.88"
Exterior Dimensions (W x D x H)29.9" x 15.9" x 16.5"

Summary

MOUNTING SPACE

WALL CONSTRUCTION

ELECTRICAL GROUNDING INSTRUCTIONS

ELECTRICAL REQUIREMENTS

Specifies voltage, frequency, and amperage requirements for proper appliance power connection.

HOOD EXHAUST DUCT

EXHAUST CONNECTION

Details required ductwork type and size for connecting the hood exhaust to the ventilation system.

REAR EXHAUST

Guidance on aligning exhaust with wall studs or preparing wall for rear/horizontal venting.

MAXIMUM DUCT LENGTH

Provides guidelines for calculating total duct length, including equivalents for elbows and adapters.

TOOLS RECOMMENDED FOR INSTALLATION

INSTALLATION HARDWARE

PREPARATION OF THE OVEN

VENTILATION SYSTEM

RECIRCULATING: NON-VENTED, DUCTLESS OPERATION

Instructions for non-vented, ductless recirculating air flow using a charcoal filter.

HORIZONTAL EXHAUST: OUTSIDE VENTILATION

Steps for configuring the fan unit for horizontal external exhaust ventilation.

VERTICAL EXHAUST: OUTSIDE VENTILATION

Instructions for rotating the fan unit and attaching the damper for vertical external exhaust ventilation.

OVEN INSTALLATION

MOUNTING PLATE

Steps for attaching the mounting plate to the wall using toggle bolts and wood screws.

MOUNTING OVEN TO THE WALL

Procedures for lifting and securing the microwave oven to the wall and mounting plate.

Related product manuals