Frigidaire FWAC16B3MSGKW User Manual

6. Lid lock button + Pause/start
button
Press Lid lock + Pause/start
button in Operation state, all
switch button invalid, except OFF
button.
Display in the process of program
1. Procedures for display
STANDBY (After the power before
run): Shows each program of some
process lamp and the initial time;
No digital pipe, no showing time.
DELAYSTART (Reservation): After
reservation washing, all the lights
go out, displays reservation time.
If no number on the display no
delay time.
Run: the lights ablaze in the
process of running, long bright if
not running.
If it has a error light long bright; If
the door lock locked, door lock
light long bright.
END LED flashing(light 0.5 S?
drown 0.5 S),at the same time
tweet 6 times (sing 0.5 S-pause
0.5 S), Screen shown in in order of
11, 22, 33, 44, 55, 66, end,
Automatically cut off the power
switch.
3837
ENG ENG
2. Alarm display
FAULT
Digital pipe error occurs:
E1: flooding water over
1h,alarm(The door switch effective,
check inlet valve, etc)
E2: Drainage time ≥ water level
switch not reset in 6 min．（ The
door switch effective， check inlet
valve， etc）
E3: alarming unless the door
closed before spin (close door
switch)
E4: alarming when Bump barrels
three consecutive.(door switch
available)
F8: Water-level sensor fault
(Change water-level sensor)
F6: communication breakdown
(Insert the communication terminal
to dial)
Fd: Electronic locks fault(check
door lock)
Non digital pipe error occurs
E1: both Lock and soak
flashing:(step first and second of
Processes)
E2: both soak and wash flashing:
(step second and third of
Processes)
E3: both wash and rinse flashing:
(step third and fourth of Processes)
E4: both rinse and spin flashing:
(step fourth and fifth of Processes)
F8: both spine and lock flashing:
(step first and fifth of Processes)
F6: Light flashing (communication
breakdown)
Fd: lock flashing (door lock
alarming)

Frigidaire FWAC16B3MSGKW Specifications

General

Brand	Frigidaire
Model	FWAC16B3MSGKW
Category	Washer
Language	English