EasyManua.ls Logo

Frigidaire LEEFM389FEB - Adjusting Your Oven Temperature; Oven Temperature Calibration Guide

Frigidaire LEEFM389FEB
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Thetemperatureintheovenhasbeenpre°setatthefactory,Whenfirstusingtheoven,be
suretofollowrecipetimesandtemperatures,ifyouthinktheovenistoohotortoocool,the
temperatureintheovencanbeadjusted,Beforeadjusting,testa recipebyusinga
temperaturesettingthatishigherorlowerthantherecommendedtemperature,Thebaking
resultsshouldhelpyoutodecidehowmuchofanadjustmentisneeded,
mNSTRUCTmONS
To adjust the oven temperature higher:
1, Press _ for6 seconds (Fig, 1
),
2, To increase the temperature use the number pads to enter the
change, (Example 30°F) @ (Fig, 2),
desired The
temperature may be increased as much as 35°F (19°C),
3, Press _ to accept the temperature change and the
display
will return to the time of day (Fig, 3), Press _o_'_to reject the
change if necessary,
PRESS
@
@
@
To adjust the oven temperature _ower:
1, Press _k_ for 6 seconds
(Fig, 4),
2, To decrease the temperature use the number pads to enter the
@
Note: Th eoven
made with this feature will
not change the Self-Clean
cycle temperature,
DISPLAY
Fig. 1
Fig. 2
Fig. 3
desired change, (Example -30°F) and then press
(Fig, 5), temperature may as as
The be decreased much
3,
35°F(19°C),
Press @ to accept the temperature change and the display
wiii return to the time of day (Fig. 6). Press @ to reject the
changeifnecessary.
Fig. 4
Fig. 5
@
@
Fig. 6
Oven
L_ght
Wire
Holder
Changing the Oven Light
The oven light bulb is located at the rear of the oven and is covered with a glass shield held by
a wire holder, The glass shield must be in place whenever the oven is in use,
To replace the oven light bulb:
1, Turn electrical power off at the main source or unplug the range,
2, Press wire holder to one side to release the glass shield,
3, Replace bulb with a new 40 watt appliance bulb,
4, Replace glass shield over bulb and snap wire holder into place,
5, Turn power back on again at the main source (or plug the range back in),
6, The clock will then need to be reset, To reset, see Setting the Clock and Minute Timer,
Be sure the range is unplugged and all parts are COOL before replacing oven
light, Wear a bather-faced glove for protection against possible broken glass,
35

Related product manuals