Fritz! 1200 - Page 11

11
Connecting the FRITZ!Repeater to the
Router via LAN
Enable Mesh (Only with FRITZ!Box Software FRITZ!OS 7 or Newer)
1. Make sure that the FRITZ!Repeater is connected with your FRITZ!Box
(router). The LED lights green.
2. Press the “Connect” button. The LED ashes green:
3. Within 2 minutes, enable Mesh on your FRITZ!Box:
• FRITZ!Box with “WPS” or “Connect/WPS” button: Press button briey
• FRITZ!Box with “WLAN” or "“WLAN/WPS” button: Press button for at least
6 seconds
When Mesh is enabled, the FRITZ!Repeater is marked with the Mesh enabled
icon under “Home Network / Mesh” in the user interface of the FRITZ!Box.