Fritz! 3000 AX - Configuring LAN Connection and Mesh; Enabling Mesh with FRITZ!OS 7.0+

Conguring a LAN Connection
The table shows how to congure a LAN connection between the
FRITZ!Repeater and the FRITZ!Box on a computer. More conguration options
can be found in our PDF manual at en.avm.de/service.
1
Plug the FRITZ!Repeater into an electrical outlet.
2
Connect the FRITZ!Repeater to your computer using a LAN cable and wait until
the Connect LED starts ashing slowly.
3
Enter http://fritz.repeater in a web browser. The user interface of the
FRITZ!Repeater appears.
4
Follow the instructions of the wizard in the user interface until conguration is
complete, selecting LAN Bridge as the type of connection.
5
Connect the FRITZ!Repeater to your FRITZ!Box using a LAN cable.
As soon as the Connection Quality and Connect LEDs light up permanently, the
FRITZ!Repeater is ready for operation.
On a FRITZ!Box with FRITZ!OS7.0 or higher, enable Mesh
1
Press the Connect button on the FRITZ!Repeater. The Connect LED ashes.
2
Within two minutes, conrm on your FRITZ!Box that Mesh has been enabled:
• FRITZ!Box with Connect/WPS or WPS button: Press button briey
• FRITZ!Box with WLAN/WPS or WLAN button: Press button for at least 6
seconds
en.avm.de/mesh
21