“go to TABLE OF CONTENTS”
51 FRIULINOX ALI GROUPS.R.L. A SOCIO UNICO
Via Treviso,4 - 33083 Taiedo di Chions (PN) -Italy
8.6.6. Evaporator probe replacement
1. Loosen the central screw closing the front panel using a
screwdriver.
2. Lift the front panel, being careful to secure it to the
rear body.
3. Remove the electric box by loosening the two locking
screws using a screwdriver.
4. The evaporator probe is identified by the RED
connector.
5. Loosen the probe connections from the board.
6. Open the belt that secures the evaporator protective
casing.
To Next Page
Loading...