11
EN
General
Safety
WARNING!
Incorrect operation or shoddy workmanship can cause serious injury or damage.
► All functions described in this document may only be carried out by trained and quali-
fied personnel after they have fully read and understood the following documents:
this document,
all documents relating to the system components, especially the safety rules!
WARNING!
An electric shock can be fatal.
Before starting work:
► turn the power source mains switch to the "O" position
► disconnect the power source from the mains
► ensure that the power source remains disconnected from the mains until all work has
been completed
► After opening the device, use a suitable measuring instrument to check that electrically
charged components (e.g. capacitors) have been discharged.
CAUTION!
Risk of injury from hot system components.
► Before starting work, allow all hot system components to cool down to room tempera-
ture (+25°C, +77°F).
Scope of supply
OPT/i TPS SpeedNetConnector
(1) Cable harness
(2) Cover
(3) 2 screws 4x12 TX20
(4) 2 cable ties
Not shown:
Installation instructions
Tools required - Screwdriver TX 20
- Screwdriver TX 25
- Cutting pliers
(2)
(1)
(3)
(4)
To Next Page
Loading...