Page 16
Push the ‘Accessory Mode Selection’ button on the DX2. Select power elevating seat by
moving the joystick left or right. Once the power elevating seat option is highlighted (as
shown to the right), moving the joystick forward or backwards will operate the function.
Once the seat reaches its highest elevation, the action stops; release the joystick at this
point.
Before driving, always be sure that the mechanism has returned the seat to its lowest
position.
The power seat elevator is fitted with a system that reduces the speed of the power
wheelchair when the seat has been elevated approximately 50mm.
WARNING! Fasten the positioning belt when using the seat elevator
WARNING! Never elevate the seat from its lowest position on an inclined
surface
WARNING! Never raise the seat when crossing bumpy or uneven surfaces
WARNING! Do not put the power wheelchair into freewheel mode with the seat
elevated
WARNING! Maintain recommended tyre pressures for good stability
STOP! Do not put your fingers, toes or any other body part or object into the
scissor mechanism while it is operating. Serious personal injury will occur.
5.7 ANSI/RESNA WC/Vol 1 – Section 19 and ISO7176-19 restraint system; if fitted.
This wheelchair conforms with the requirements of ANRI/RESNA WC/19 and ISO7176-19.
Magic Mobility recommends that wheelchair users are NOT transported in vehicles of any
kind while in wheelchairs. The Department of Transportation has not approved any tie-down
system for transportation of a user while in a wheelchair in a moving vehicle of any type. It is
Magic Mobility’s position that users of wheelchairs should be transferred into appropriate
seating in vehicles for transportation and use be made of the restraints made available by the
auto industry.
For detailed information see Appendix A - ANSI/RESNA WC/Vol 1 – Section 19 &
ISO7176-19 restraint system; if fitted
NOTE:
ANSI = American National Standards Institute
RESNA = Rehabilitation Engineering and Assistive Technology Society of North America
ISO = International Organisation for Standardisation
To Next Page
Loading...
Need help?
General