Manual Revision Code: FRONTLINE-SRL-04 10-19-20
3
INSPECTION FREQUENCY:
SRLs shall be inspected by the authorized person or rescuer before each use.
The inspection shall be conducted by a competent person other than the user.
The competent person shall use the Inspection Schedule and checking list for appropriate inspection
intervals and procedures.
Results of the Competent person inspection should be recorded in the " Inspection and Maintenance Log"
on the back pages of instruction.
APPLICATIONS:
Purpose:
This product is part of a personal fall arrest, restraint, work positioning, suspension, or rescue system.
A Personal Fall Arrest System (PFAS) is typically composed of an anchorage and a Full Body Harness (FBH),
with a connecting device, i.e., a Shock Absorbing Lanyard (SAL), or a Self-Retracting Device (SRL), attach to
the dorsal D-ring of the FBH.
SRLs are designed for use in applications where falls may occur.
SRLs covered by this manual, SRLs may be used in many situations where a combination of work mobility
and fall protection is required. (i.e. inspection work, general construction, maintenance work, oil
production, confined space work, etc.)
Standards:
SRLs confirm to the national standard identified on the label. Refer to local, state, and federal
(OSHA)requirements governing occupational safety for additional information. The standard are ANSI
Z359.14-2014 - Safety Requirement for Self-Retracting Device for Personal Fall Arrest and Rescue Systems.
Free Fall:
When anchorage overhead, SRLs will limit the free fall distance to 2ft. (61cm), or less. To avoid increased
fall distances, anchor the SRL directly above the work level. Avoid working where your lifeline may cross or
tangle with that of another worker. Never clamp, knot, or prevent the lifeline from retracting or being taut.
To Next Page
Loading...
Need help?
General
