At the "record view" interface, you may see the main menu on the bottom of the page,
they are (from left to right): ESC X RST
There is an underline when you selected the menu ( the "ESC" has been chosen in Fig.
10), press "Threshold" shortly to move the underline from left to right , after the
underline moved to your ideal menu, press shortly to execute it.
Description of every individual menu:
: Page up to the last 10 recording
: Page down to the next 10 recording
: Page up to the last 100 recording
: Page down to the next 100 recording
ESC: Exit the "record view" interface ( same as press )
X: Select one or more than one recording to delete
RST: Reset the recording memory, this operation is not reversible and it'll take 5 seconds
to complete with power supply can not be disconnected, otherwise it may damage the
chip of tester.
At the "record view" interface, press button to move "X" upward one step, press
button to move "X" downward one step. In Fig. 10, the interface explains that
there are totally 3 testing results inside, "low" means the saving power value is lower
than the value of the threshold setting. In Fig. 11, "high" means the saving power value
is higher than the value of the threshold setting. The digital means the power value of
corresponding wavelength.
REF/SEL
Fig.10
3 1310 1490 1550
Esc X RST
low
low
low
low
low
low
low
low
low
1:
2:
3:
10-03-03 11: 43: 15
MODE
dBm/dB
To Next Page
Loading...