FSA E-SYSTEM - Advanced Error Diagnostics

2121
4.6.9 CAN error communication error between battery and
controller.
cables shut down the system. Check all
the connections between the bat- tery and the motor. Restart the system.
3.7.12 Ext.batt. detach Range Extender disconnected while the
system is active
cable/ connector shut down the system. Check all
the connections. Restart the sy- stem.
5.1.3 cell undervolt. (at least) in one cells the tension is too
low
battery cells charge the battery. If the problem
still remain, contact the support
5.1.4 cell overvoltage (at least) in one cells the tension is too
high
battery cells contact the support
5.1.5 overcurrent overcurrent during discharging battery/ motor driver restart the battery. If the problem
still remain, contact the support
5.1.6 short circuit short-circuit protection battery/ motor driver contact the support
5.1.7 overcurrent overcurrent during charging battery charger/ battery contact the support
4.2.10 motor error motor connections motor/ controller/wi-
rings
contact the support
6.1.2 overtemperature cells overtemperature battery cells contact the support
6.1.3 cell undervolt. (at least) in one cells the tension is too
low
battery cells contact the support
6.1.4 cell overvoltage (at least) in one cells the tension is too
high
battery cells contact the support
6.1.5 overcurrent overcurrent during discharging battery contact the support
6.1.7 overcurrent overcurrent during charging battery contact the support
6.1.10 Generic HW BMS hardware battery contact the support