6. Trouble Shooting
Use the table below to solve minor problems.
No LED display on the
front panel.
Charge the UPS at least 6 hours.
Replace the battery with the same
type of battery.
The UPS is not turned on.
Press the power switch again to turn
on the UPS.
Alarm continuously
sounds when the
mains is normal.
Remove some loads first. Before
reconnecting equipment, please
verify that the load matches the UPS
capability specified in the specs.
When power fails,
back-up time is
shorten.
Remove some critical load.
Battery voltage is too low.
Charge the UPS at least 6 hours.
Battery defect. It might be
due to high temperature
operation environment, or
improper operation to battery.
Replace the battery with the same
type of battery.
The mains is normal
but LED is flashing.
Reconnect the power cord properly.
110/120 VAC or 220/230/240 VAC
Typical 2-6 ms, 10 ms max.
4-6 hours recover to 90% capacity
0-90 % RH @ 0-40° C (non-condensing)
Supports Windows® 2000/2003/XP/Vista/2008, Windows® 7,
Linux, Unix and MAC
1. Lieferumfang
Im Lieferumfang sollten Sie folgendes finden:
- UPS Einheit
- Schnell Installationsanleitung
- Kommunikationskabel ( nur für USB/RS-232 port Modell)
- Stromkabel ( nur für IEC-input Modell)
2. Produktübersicht
Vorderansicht:
Rü ckansicht:
Line Interactive UPS Quick Guide V. 2.0
Netzschalter
UPS status LED
AC Modus: leuchtet grün
Batterie Modus: blinkt grün
Ausgabe Anschluss
AC Input
Optionen
Schutzschalter
USB com. port
Modem / Telefon /
Netzwerk
Ü berspannungsschutz
RS-232 com. Port