23
BEFORE THE FIRST USE
Before starting operations in this section:
• Find a place where there is power supply nearby.
• Install the exhaust hose and adjust the window position well.
• The supplied small white clips must be mounted on the window kit.
• Insert the power cord into a grounded AC220~240V/50Hz socket.
• Press the power button to turn on the air-conditioner.
• Set the temperature range: 16°C-31°C.
• Check whether the exhaust hose has been mounted properly.
• When using functions on cooling and dehumidifying, allow at least 3
minutes between powering off and powering on.
USE
Cooling operation
• Press the “mode“ button till the “Cool“ icon appears.
• Press the or button to select a desired room temperature.
• Allow around 5 minutes for the cooling to start.
• Press the “fan speed” button to adjust airow.
Dehumidifying operation
• Press the “Mode“ button until the “dehumidify indicator lamp“ blinks.
• The temperature will automatically be selected.
• The fan speed will automatically be selected.
Timer operation
Timer ON setting
• When the air-conditioner is OFF, press the “Timer“ button and select a
desired ON time and adjust using the temperature buttons.
• The ON time can be adjusted to anytime in 0-24 hours.
Timer OFF setting
• When the air-conditioner ON, press “Timer“ button and select a desired
OFF time through the temperature buttons.
• The OFF time can be adjusted to anytime in 0-24 hours.
Drainage
• After a lengthy operation and before storage, you will need to drain the
water that has been collected. Please prepare a suitable location or tray
to collect the water and remove the rubber stop from the drainage hole
at the bottom of the unit. The water will then begin to drain. After this
has stopped, you can insert the drain stop.
77.777000.01.001_77.779000.01.001_IM.indd 2377.777000.01.001_77.779000.01.001_IM.indd 23 9-11-2020 09:55:189-11-2020 09:55:18
To Next Page
Loading...