Why is the yellow indicator light on my Fubag IR 140?
The yellow indicator light might be on due to several reasons: * Poor ventilation leading to overheat protection. Improve the ventilation. * High ambient temperature. The system should automatically recover when the temperature decreases. * Exceeding the rated duty cycle.
What to do if the electrode holder and cable are getting hot on my Fubag IR 140 Welding System?
If the electrode holder and cable are overheating, and the polar sockets are also hot, consider the following: * The electrode holder's capacity might be too small. Replace it with a higher capacity one. * The cable size might be insufficient. Replace it with a cable that meets the requirements. * The socket might be loose. Clean any oxidation and tighten it.
What to do if the cooling fan is not working on my Fubag IR 140?
If the cooling fan isn't working or is turning very slowly, check the following: * The switch might be broken. Replace the switch. * The fan itself might be broken. Replace or repair the fan. * A wire might be broken or disconnected. Check the connection.
How to fix adjustment knob if it doesn't work on Fubag Welding System?
If the adjustment knob on the front panel isn't working, it's likely that the potentiometer (current regulation) is broken. Replace the potentiometer.
General| Type | Inverter |
|---|---|
| Welding Current Range | 10-140 A |
| Open Circuit Voltage | 65 V |
| Electrode Diameter | 1.6-3.2 mm |
| Protection Class | IP21S |
| Insulation Class | F |
| Input Voltage | 230 V |
To Next Page
