Error Code
549
Problem Solving
15
024-705
[Cause] The template of the specified force annotation was not found in
the machine.
[Remedy] Delete the document in the folder of the machine, and then
select [Store to Folder] again from the print driver to store the
document.
024-742
[Cause] Booklet printing was specified for printer properties, but the
number of print pages for the job exceeded the maximum
number allowed for booklet creation.
[Remedy] Change the printer properties setting to split the pages
appropriately to create separate volumes, or to cancel the
booklet creation setting.
024-746
[Cause] The specified paper type is not compatible with the specified
paper size, paper tray, output tray, or 2 sided printing.
[Remedy] Confirm the print data.
024-747
[Cause] Incompatible print parameters are used. The combination of
the specified features such as Document Size, Paper Size, Paper
Tray, 2 sided printing, and Output Tray is incompatible.
[Remedy] Confirm the print data, and try printing again.
024-748
[Cause] The number of digits specified in [Bates Stamp - Number of
Digits] screen does not match the value specified in [Starting
Number].
[Remedy] Set [Bates Stamp - Number of Digits] to the value specified in
[Starting Number] or to [Auto Assign].
024-775
[Cause] Booklet printing was specified for printer properties, but the
number of print pages for the job exceeded the maximum
number allowed for booklet creation.
[Remedy] Change the printer properties setting to split the pages
appropriately to create separate volumes, or to cancel the
booklet creation setting.
025-596
025-597
[Cause] An error occurred with the hard disk.
[Remedy] Replace the hard disk.
026-400
[Cause] More than two devices are connected to the USB host port.
[Remedy] Disconnect the third or more devices so that the number of
connected devices becomes two. If the error still is not resolved,
switch off the machine power, make sure that the touch screen
is blank, and then switch on the machine power.
026-700
[Cause] By Address Book operation, the machine received an
unsupported protocol from the LDAP server.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
026-701
[Cause] The number of queries submitted to the Address Book exceeded
the machine's processing capability.
[Remedy] Wait for a while and execute the operation again. If the only
one query is being submitted to the Address Book, the
machine’s software may be defective. Contact our Customer
Support Center.
Error Code
Cause and Remedy
To Next Page
Loading...
