Problem Solving
550
Problem Solving
15
026-702
[Cause] The number of accesses from the LDAP server to the machine by
Address Book operation exceeded the machine's processing
capability.
[Remedy] Wait for a while and execute the operation again. If the error
still is not resolved, contact our Customer Support Center.
026-703
[Cause] Authentication is canceled when adding documents during
faxing or scanning.
[Remedy] Authenticate when adding documents.
026-704
[Cause] An error occurred during processing DocuWorks documents.
[Remedy] Print using the print driver (PCL, etc.) from DocuWorks Viewer.
026-705
[Cause] Unable to process for DocuWorks documents because of
insufficient memory space.
026-706
[Cause] Attempted to print a DocuWorks document of which printing is
prohibited.
[Remedy] Release the print prohibited settings using DocuWorks Viewer,
and then execute the operation again.
026-707
[Cause] When processing password-protected DocuWorks documents,
the password entered does not match that of the DocuWorks
document.
[Remedy] Set the correct password on ContentsBridge.
026-708
[Cause] Exceeded the maximum limit for the scan data size that can be
stored for one job with Store & Send Link.
[Remedy] Take one of the following measures:
1) Reduce the resolution (scan quality) of the scan parameters
and execute the operation again.
2) Reduce the image with magnification of the scan parameters
(such as A3 > A4) and then execute the operation again.
3) If [Store & Send Link - Maximum File Size] is set to a small
value, increase the value.
026-709
[Cause] The capacity of the hard disk that can be used to store scan
data with Store & Send Link is insufficient.
[Remedy] Wait around one day, and when capacity becomes available as
a result of the automatic deletion of files, execute the operation
again.
026-710
[Cause] The machine has received and e-mail encrypted by S/ MIME,
but does not support the encryption method.
[Remedy] Take one of the following measures:
z
Ask the sender to send the e-mail encrypted by 3DES.
z
Disable the FIPS140 validation mode of the machine.
Error Code
Cause and Remedy
To Next Page
Loading...
