Adjust Image Transfer
677
Appendix
16
11 Enter the [Side 1] and the [Side 2] values you
selected in step 10.
12 Select [Adjust].
The specified transfer output values will be applied when the paper type of the job is the
same as the paper type selected in step 7.
13 Select [Close].
Adjusting the transfer output value by scanning the sample printout
1 Press the <Log In/Out> button and enter the
System Administration mode.
For how to enter the System Administration mode, refer to
"System Settings Procedure" (P.138).
2 Select [Tools] on the Services Home screen.
3 Select [System Settings] > [Common Service
Settings] > [Maintenance].
4 Select [Adjust Image Transfer].
5 Select [Paper Type].
To Next Page
Loading...
