Fax Service Settings
285
Tools
5
Broadcast Checkbox on 1st Tab
Specify whether or not to show the [Enable Broadcast] checkbox in the [Fax/Internet Fax]
screen to explicitly express broadcast directions.
Chain Dial
Allows you to combine the fax numbers registered in one-touch button, speed dial, and
address book respectively and the numbers entered using the numeric keypad to specify as
one recipient. You can select from [No] or [Yes].
z
This item is available when [Type 1] is set for [Address Book Type] under [Tools] > [Address Book Settings].
Manual Redial List - Saved Entries
Specify the number of redial destinations saved.
Manual Redial List - Dial Mode
Specify the destination type saved as a redial destination number.
When you deselect all the check boxes, the Redial feature becomes disabled.
Transmission Header Text - Polling
Set whether or not to attach a transmission header to a polling file.
A "polling file" means that a document is stored in the machine's public folder for polling,
and can then be sent by an operation from the other party.
Polled Files - Auto Delete
Set whether or not to automatically delete a polling file after transmission.
Rotate 90 degrees
Set whether or not to automatically rotate a document if its image must be reduced in size
unless it is rotated.
z
If an arbitrary magnification is specified in [Reduce/Enlarge], the Rotate 90 Degrees feature does not
function.
G3 Sender ID - Fax
When using G3 communications, you can select whether to notify G3 ID to recipients for
fax.
G3 Sender ID - IP Fax (SIP)
When using G3 communications, you can select whether to notify G3 ID to recipients for IP
Fax (SIP).
Save Undelivered Faxes
Set whether or not to save a fax document if a fax transmission fails. When [Yes] is
selected, the [Undelivered Faxes] button appears on the [Secure Print Jobs & More] tab of
the [Job Status] screen. Select this button to send the fax document again.
z
For details on Undelivered Faxes, refer to "Job Status" > "Printing and Deleting Stored Jobs" > "Undelivered Faxes" in the User
Guide.
To Next Page
Loading...
