EasyManuals Logo

Fuji Xerox ApeosPort-VI C3371 Administrator's Guide

Fuji Xerox ApeosPort-VI C3371
889 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #656 background imageLoading...
Page #656 background image
Problem Solving
656
Problem Solving
15
116-747
[Cause] The paper margin value is too large for the HP-GL/2 active
coordinates area.
[Remedy] Decrease the paper margin value, and then execute the
operation again.
116-748
[Cause] There is no plot data in the HP-GL/2 print data.
[Remedy] Check the print data.
116-749
[Cause] The job was cancelled because the specified font does not exist.
[Remedy] Install the font, or set the print driver to replace the font.
116-750
[Cause] Banner sheet tray malfunction
[Remedy] Restore the tray to normal condition or change the Banner
sheet tray.
116-751
[Cause] The process has been canceled because the hard disk is full.
[Remedy] Delete stored data in the hard disk. If the error still is not
resolved, split the file and send the job again.
116-752
[Cause] The descriptions of the PDF or XPS printing job ticket have a
problem.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
Note
z
XPS stands for XML Paper Specification.
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
[Cause] The data was automatically modified because it included an
invalid parameter.
[Remedy] The printed image may be incomplete. Confirm with the sender
whether the image has a problem, or ask the sender to send the
data again. When using the Internet Fax Forwarding feature,
confirm its condition with the e-mail recipient.
116-780
[Cause] There is a problem with the document attached to the received
e-mail.
[Remedy] Check the attached document.
116-790
[Cause] Probable causes are as follows:
1) If the operator cancelled printing a document that was
received using the Store Fax - Local Folder or Store Internet
Fax - Local Folder feature: The first set of the document is not
stapled.
2) For causes other than 1)
No set of the document is stapled.
[Remedy] For 1), manually staple the first set of the document. Or, do not
cancel printing of a document that is received using the Store
Fax - Local Folder or Store Internet Fax - Local Folder feature.
For 2), check whether the staple position has been correctly
specified, and try printing again.
Error Code
Cause and Remedy

Table of Contents

Other manuals for Fuji Xerox ApeosPort-VI C3371

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-VI C3371 and is the answer not in the manual?

Fuji Xerox ApeosPort-VI C3371 Specifications

General IconGeneral
BrandFuji Xerox
ModelApeosPort-VI C3371
CategoryAll in One Printer
LanguageEnglish

Related product manuals