Device Components
41
Interface Decurler Module D1 (optional) and Inserter D1 (optional)
1 Error lamp
If the priority device lamp is blinking, first clear the paper jam.
2De-curl button
You can adjust the curling by selecting the De-curl button. This curl adjustment function is
for adjustments during printing.
3 Interface Decurler Module front door
Open this door to clear paper jams.
4 Inserter Tray (Tray T1)
Load paper for covers or separators. Paper loaded here is not used for printing.
5 Error lamp
If a paper jam occurs, the lamp of the jammed location lights up. If the priority device lamp
is blinking, first clear the paper jam.
6De-curl button
Used when the curls are not corrected even after adjusting the Interface Decurler Module
to the highest (or lowest) value. The adjustment method is the same as the adjustment
method of Interface Decurler Module. However, there are 3 adjustment levels, OFF/UP/
DOWN.
7 Inserter front door
Open this door when clearing paper jams.
To Next Page
Loading...
