13 Appendix
304
Print control 152
(Eject
command SP)
Sets the command that indicates the end of plotting. When the command
specified here is received, plotting is terminated and the paper is output.
[0] (Default): OFF
[1]: ON
The default value is [ON] for SPO, and [OFF] for the others.
If multiple commands are specified, when one of the commands is received,
plotting is terminated and the paper is output.
153
(Eject
command SPO)
154
(Eject
command NR)
155
(Eject
command FR)
156
(Eject
command PG)
157
(Eject
command AF)
158
(Eject
command AH)
159
(Scaling)
Sets whether the original size is enlarged or reduced so that the document
size fits the paper size.
[0]: OFF
[1] (Default): ON
160
(Scaling mode)
Selects the document size for auto scaling: A series paper (A0, A1, A2, A3, A4,
and A5) or the active coordinate area which is determined accordance with
the setting selected in Area Determination Mode.
[0] (Default): Paper Size
[1]: Active Coordinate Area
[Active Coordinate Area] can be selected only when [Auto layout] is set to [ON].
When [OFF] is selected, [Scaling mode] becomes [Paper Size].
The setting of the scaling mode is valid when [Document size] is set to [Auto].
161
(Active area
determination
command)
Sets the method to obtain the active coordinate area when auto scaling is
being used.
[0] (Default): Auto
[1]: PS
[2]: IW
[3]: IP
[4]: Adapted
The setting of the active area determination command is valid when [Document
size] is set to [Auto].
162
(Paper margin)
Sets the paper margin when auto scaling is being used.
[0] - [99] (Default: 0): 0 to 99 mm
The setting of the paper margin is valid when [Document size] is set to [Auto].
163
(Image
enhancement)
Sets whether to perform image enhancement, which artificially increases the
resolution of an image and smooth its edges.
[0]: OFF
[1] (Default): ON
Parameter Item No. Value
To Next Page
Loading...
Need help?
General
