Emulation
303
Extended Settings
Color mode 105 [0]: Color
[1] (Default): Grayscale
[2]: Black pen
Parameter Item No. Value
Auto layout 106 Selects whether to perform auto layout of the document or not.
[0] (Default): ON
[1]: OFF
Active palette 107 Selects whether to use a pen specified by command or set on the panel.
[0] (Default): Command
[1]: Panel
No. of prints 108 [1] - [250] (Default: 1): 1 - 250
2 sided printing 110 [0] (Default): None
[1]: Head to head
[2]: Head to toe
Alphanumeric
fonts
112 Sets the font for single-byte characters.
For more information on fonts, refer to "Available Fonts" (P.282).
[0] (Default): Stroke
[1]: Roman
[2]: Sans serif
Position
adjustment
113
(Vertical
position
adjustment)
Adjusts the hard clip area vertically or horizontally. You can set from -250
mm to +250 mm in 1 mm increments.
[0] (Default): Does not move the hard clip area.
[1] - [250]: -250 to -1 mm
[251] - [500]: +1 to +250 mm
Data outside the printable area is not printed regardless of the adjustment of the
print position. In addition, data moved outside the printable area as a result of
adjusting the print position is not printed.
114
(Horizontal
position
adjustment)
Number of sets 115 Sets the method for specifying the print sets.
[0] (Default): Protocol
[1]: Panel
[2]: Command
Print control 150
(HP-GL mode)
Selects a graphics language. This setting affects to IW, OW, and UC of HP-
GL/2 commands.
[0] (Default): HP-GL
[1]: HP-GL/2
To print HP-GL/2 command that does not include BP command, select [HP-GL/2].
151
(Hard clip)
Sets the size of hard clip area.
In HP-GL mode, the plottable area is determined in line with the paper size,
apart from the printable area. This area is called the "hard clip area", and
determines the maximum range of pen movement. Accordingly, images
cannot be drawn outside the boundary of the hard clip area.
[0]: Standard
[2] (Default): Paper
Parameter Item No. Value
To Next Page
Loading...
Need help?
General
