Fuji Xerox C2265 - Page 123

Fuji Xerox C2265/C2263 Security Target
- 118 - Copyright

2016 by Fuji Xerox Co., Ltd
・ Refer to the setting of Hard Disk Data Overwrite, enable/disable it, and set the number of
pass (overwrite procedure);
・ Refer to the setting of Hard Disk Data Encryption, and enable/disable it;
・ Set the cryptographic seed key for Hard Disk Data Encryption;
・ Refer to the setting on the use of password entered from MFD control panel in user
authentication, and enable/disable it;
・ Refer to the setting of access denial due to authentication failure of system administrator,
enable/disable it, and set the allowable number of failures;
・ Refer to the setting of key operator ID and change the ID and password (only a key
operator is privileged);
・ Refer to the setting of ID of SA and general user and change the ID and password(with
local authentication only);
・ Refer to and set the minimum password length (for general user and SA, with local
authentication only);
・ Refer to the setting of SSL/TLS communication of Internal Network Data Protection,
enable/disable it, and configure the details;
・ Refer to the setting of IPSec communication of Internal Network Data Protection,
enable/disable it, and configure the details;
・ Refer to the setting of S/MIME communication of Internal Network Data Protection,
enable/disable it, and configure the details;
・ Refer to the setting of User Authentication and select disable/Local Authentication/Remote
Authentication, and configure the details;
・ Refer to the setting of Store print and set store/print;
・ Refer to and set date and time;
・ Refer to the setting of Auto Clear of Control Panel, enable/disable it, and configure the
deletion time;
・ Refer to the setting of Self Test, and enable/disable it;
・ Refer to the setting of Report Print, and configure the administrators only/all users;
With CWIS function, the settings of the following TOE security functions can be referred to
and changed from a system administrator client via Web browser.
・ Refer to the setting of key operator ID and change the ID and password (only a key
operator is privileged);
・ Refer to the setting of ID of SA and general user and change the ID and password;
・ Refer to the setting of access denial due to authentication failures of system administrator,
enable/disable it, and set the allowable number of the failures before access denial;
・ Refer to and set the minimum password length (for general user and SA, with local
authentication only);
・ Refer to the setting of Security Audit Log and enable/disable it,
・ (When Security Audit Log is enabled, security audit log data can be downloaded in the
form of tab-delimited text to a system administrator client.);
・ Refer to the setting of SSL/TLS communication of Internal Network Data Protection,