Setup
241
Tools
5
îš„Name/E-mail Address
Displays the recipient name or e-mail address specified.
îš„Subject
Enter a subject using the keyboard displayed.
îš„Delete Recipient
Deletes all information for the selected recipient information.
îš„Edit
Displays the [Edit Recipient] screen, which allows you to check or change the recipient
selected.
For more information on the [Edit Recipient] screen, refer to "5 Scan" in the User Guide.
îš„File Format
Select an output file format.
For more information on the [File Format] screen, refer to "5 Scan" in the User Guide.
îš„Resend Attempts
Set whether or not to try sending again if a transmission fails. If you select [On], set the
number of resend attempts and interval.
z
Resend Attempts
Set the transmission retry count from 1 to 5.
z
Resend Interval
Set the transmission retry interval from 30 to 300 seconds.
îš„Encryption
Set whether or not to encrypt the e-mail transmission.
Note • To encrypt e-mail transmission, the configuration of S/MIME is required.
• To encrypt e-mail transmission, a certificate is required.
• To enable encryption, select [On] before specifying an address. [On] will be disabled after an
address is specified.
îš„Digital Signature
Select whether or not to add digital signature.
Note • To add digital signature, the configuration of S/MIME is required.
• To add digital signature, a certificate is required.
Transfer via FTP (1), Transfer via FTP (2) (ApeosPort Series Models Only)
[Transfer via FTP (2)] will be displayed when [Transfer via FTP (1)] is configured.
Specify where FTP forwarding is to be stored.
îš„Address Book
When the server address is registered on the Address Book, you can specify the address
from the Address Book. The specified address appears in the [Transfer via FTP (1)] or
[Transfer via FTP (2)] screen.
For more information on the Address Book, refer to "Add Address Book Entry" (P.244).
îš„File Format
Specify an output file format.
For more information on the [File Format] screen, refer to "5 Scan" in the User Guide.
îš„Resend Attempts
Set whether or not to try sending again if a transmission fails. If you select [On], set the
number of resend attempts and interval.
z
Resend Attempts
Set the transmission retry count from 1 to 5.
z
Resend Interval
Set the transmission retry interval from 30 to 300 seconds.
To Next Page
Loading...
Need help?
General
