4 Fax
252
Fax
4
îš„ F Code Method
This method can be used among machines that support the F Code and the Relay Broadcast
features.
Fax Signal Method
Register the following information in the address numbers of initiating stations in advance.
For information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the
Administrator Guide.
For information on the setting items to be registered in a primary relay station and a secondary relay station, refer to the
documentations provided with them.
1 Select an address number or group dial number to which a remote relay broadcast is
registered, and press the <Start> button.
DTMF Method
The following two types are available in the DTMF method: Auto Send and Manual Send.
For information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the
Administrator Guide.
For information on the setting items to be registered in a primary relay station and a secondary relay station, refer to the
documentations provided with them.
Note • You can specify any machine that supports our DTMF method feature.
îš„ Auto Send (Transmitting without picking up the receiver)
1 Select [New Recipients] to display the keyboard on the touch screen and enter in the
following format.
z
Password
A pre-registered 2-digit number
Note • By default, no password is set. For setting a password, contact our Customer Support Center. If a
password is not set, you do not need to enter one.
z
Relay Station ID
The last two digits of the initiating station address number registered at the primary relay
station
z
Address Number
The address number for the secondary relay station registered at the primary relay
station
You can register the above dialing format in an address number to send using the address number. For information on how
to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
2 Select [+ Add] to perform Multiple Relay Broadcast.
Where Contents
Initiating
Station
Assign the relay station to an address number (0001 to 2000) to set up the Relay
Broadcast feature.
z
Register the last two digits of the address number of the initiating station (which
is already registered at a primary relay station) as a relay station ID.
z
Register the address numbers or group dial number of the secondary relay
stations (which are registered at a primary relay station) as broadcast recipients.
Relay
station ID
Address
number
Password
The 1st relay station
telephone number
To Next Page
Loading...
Need help?
General
