Fuji Xerox DocuCentre-VI C2271 - Page 237

Connectivity & Network Setup
237
Tools
5
 WSD Print - Port Status
Select [Enabled] to use WSD Print.
Set this when you search a device on a network from Windows Vista
®
, Windows 7, Windows
8, Windows 8.1, Windows Server
®
2012, or Windows Server 2012 R2.
 WSD Scan - Port Status
Select [Enabled] to use WSD Scan.
Set this when you search a device on a network from Windows Vista, Windows 7, Windows
8, Windows 8.1, Windows Server 2012, or Windows Server 2012 R2.
 Port Number
Enter a port number from 1 to 65535.
The default value is 80.
Important
z
Do not use a number that is the same as a port number of another port. However, you can use the same port
number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP, WebDAV, and Web
Services on Devices (WSD)).
Internet Services (HTTP)
 Port Status
Select [Enabled] to use CentreWare Internet Services.
Reference
z
For more information about CentreWare Internet Services, refer to "CentreWare Internet Services Settings" (P.365).
 Port Number
Enter a port number for the Internet Services from 1 to 65535.
The default value is 80.
Important
z
Do not use a number that is the same as a port number of another port. However, you can use the same port
number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP, WebDAV, and Web
Services on Devices (WSD)).
Note
z
You cannot select [Port Number], if HTTP port is disabled. To configure [Port Number], enable port status and
reboot the machine, and then configure [Port Number].
SOAP
 Port Status
Select [Enabled] when you use an application program such as Device Setup.
 Port Number
Enter a port number for SOAP from 1 to 65535.
The default value is 80.
Important
z
Do not use a number that is the same as a port number of another port. However, you can use the same port
number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP, WebDAV, and Web
Services on Devices (WSD)).