Power Saver Mode
27
Before Using the Machine
1
9
Select [Close].
Deactivating Smart WelcomEyes
When you do not use Smart WelcomEyes, follow the procedures below.
1
Press the <Log In/Out> button.
2
Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter]. When a passcode is required, select [Next] and
enter the system administrator’s passcode, and select [Enter].
z
The default user ID is "11111".
z
The default passcode is "x-admin".
3
Select [Tools] on the Services Home screen.
z
When the Services Home screen is not displayed on the touch screen, press the <Services Home> button.
4
Select [System Settings] > [Common Service Settings] > [Power Saver Settings].
5
Select [Smart WelcomEyes] and then select [Change Settings].
To Next Page
Loading...
