29
Home > Paper Handling > Load Paper > Load and Print Using the Multi-purpose Tray (MP Tray) > Load and
Print Thick Paper and Labels Using the MP Tray
Load and Print Thick Paper and Labels Using the MP Tray
1.
Open the machine's back cover (the face up output tray).
2.
On the front of the machine, open the MP tray and lower it gently.
3.
Pull out the MP tray support (1) and unfold the flap (2).
4.
Slide the MP tray paper guides to fit the width of the paper that you are using. If the paper guide on the right
side has a lever, press it and slide the paper guide.
5.
Load paper or labels in the MP tray.
When the back cover (face up output tray) is pulled down, the machine has a straight paper path from the MP
tray through to the back of the machine. Use this paper feed and output method when you print on thick paper
or labels.
When you load a different size and type of paper in the tray, you must change the Paper Size and Paper Type
settings in the machine or on your computer, also.
To Next Page
Loading...
Need help?
General
