14
Method of
mounting
How to mount corporation stop
When there is a foaming fitting at the tip end
of the water tap
Remove a set of
the foaming fittings.
Turn the accessory
for outside screw
or inside screw with
a coin or a similar
object, and install
the corporation
stop tightening
cap to the water
tap.
Apply the corporation stop
horizontally from below and
tighten the corporation
stop tightening cap.
Corporation stop
tightening cap
For inside screw
For outside screw
●
●
Foaming fittings
●
●
●
●
Pass through the
corporation stop
tightening cap.
Water may leak when installing the corporation stop in a plastic water tap.
It is recommended to replace the water tap.
Information
Packing
●
CAUTION
Do not use any tools to
mount the corporation stop
tightening cap.
(Breakage may result.)
Installation of this part.
To Next Page
Loading...