30
Maintenance
Maintenance
Anti-freezing
Drain water in seasons when tap water freezes in cold regions because water retained in
the main body and water supply hose may freeze, resulting in breakage of the main body
and hoses.
1
2
3
Corporation stop
tightening cap
Set the water selection lever to
the “Raw” side.
Water supply
hose
Set the water selection lever to the “Raw” side.
Remove the water supply hose from the
corporation stop, and place in a location
lower than the main body to drain water.
Thermally insulate the main body with
a towel or the like, or place in a warm place.
Moisten a soft cloth with water or diluted kitchen detergent (neutral) and firmly squeeze it to wipe off
contamination on the main body and corporation stop.
●
Maintenance of corporation stop
If contaminants have accumulated in the metal mesh of the corporation stop, the metal mesh will clog and
the water amount will decrease. When the water amount of “Ionized water and purified water,”
“tap water shower” or “tap water straight” has decreased or if used for a long time (6 months or longer),
disassemble the corporation stop and remove contaminants which have accumulated in the metal mesh
and shower part with a toothbrush or the like.
- Be careful not to lose parts when disassembling.
- When assembling, refer to the diagram so as not to
confuse the assembly order.
Do not splash water on or wash the main body.
(Electric leakage or electric shock may result.)
Keep dry
Note
Also remove contaminants
in the shower part with
a toothbrush or the like.
Packing
Metal mesh
●
●
●
●
●
●
To Next Page
Loading...