29
Maintenance
Cleaning inside of the main body
●
In order to remove calcium adhering to the electrode plate in the main body and keep the generating
function, the electrode plate is automatically cleaned.
When the total water passing amount of the
“Alkaline 1, 2, 3” and “Strong Alkaline” exceeds
approximately 10 liters.
When water is passed after automatic cleaning
ends, generation is started after the cleaned
water is discharged.
※The “Cleaning（洗浄中）” mark and “Preparing
（準備中）” mark flash on the LCD monitor
and the buzzer sounds (
approximately 6 seconds
+ preparing time) while the cleaned water is
discharged.
Do not use.
The electrode plates are automatically cleaned.
(for approximately 40 seconds)
The “Cleaning（洗浄中）” mark is displayed on the
LCD monitor during cleaning.
After cleaning finishes, the “Cleaning（洗浄中）”
mark turns off, and the cleaned water comes out
from the drain hose.
Tighten the cock of water tap. Or set the Ionized
water, purified water, tap water selection lever to
the “Raw” side.
After approximately 30 minutes
Note
・When water is passed during automatic cleaning, discard the water until the indication on the LCD monitor
changes from the “Preparing（準備中）” mark to the “Generating（生成中）” mark.
To Next Page
Loading...