Fujiiryoki HWP-77EN - Page 18

18
Method of
mounting
②
①
●
●
Installation of main body
4
3
2
1
Installation of this part.
●
●
Connection of the water supply hose
●
When installing the corporation stop to a water tap, set the water supply hose to be flexible
so as to allow the water tap to swing to both sides.
Note
Do not bend or twist the water supply hose. (Water leakage may result.)
Do not install to water tap dedicated to hot water. (Failure may result.)
:KHQFRQQHFWLQJWRDFRPELQDWLRQWDSGRQRWSDVVKRWZDWHU&RUKLJKHU
(Failure may result.)
Prohibited
● If the water supply hose is excessively long,
it is recommended to cut the hose straight
for use.
Hose fixing band
Remove the hose tightening cap from
the corporation stop and pass it
through the water supply hose.（）
Firmly tighten the hose tightening cap.
Ɣ 'RQRWXVHDQ\WRROV
(Breakage of the corporation stop
may result.)
Fix the water supply hose with
the hose fixing band.
Ɣ 'RQRWFUXVKWKHKRVHZKHQIL[LQJ
Good example
Bad example
Gap
Hose tightening cap
Water supply hose
Insert the water supply hose all
the way.（）