To Next PageTo Next PageWhat to do if the Fujikura 45S CHARGE LED blinks during battery recharge?
If the CHARGE LED blinks during battery recharge, it could indicate that the battery pack has a fault or has reached the end of its service life. You should install a new battery pack. If the LED continues to blink after installing a new battery, contact the authorized distributor.
How to turn off the Fujikura 45S if the power does not turn off when pressing the ON/OFF key?
If the power does not turn off when pressing the ON/OFF key, press and hold the key until the LED color changes from green to red.
How to turn on the Fujikura Welding System if the power does not turn on when pressing the ON/OFF key?
If the power does not turn on when pressing the ON/OFF key, charge the battery.
Why is the battery indicator not displayed on my Fujikura 45S?
The battery indicator is not displayed on the screen when using the AC adapter.
General| Protection Class | IP52 |
|---|---|
| Cladding Diameter | 80 - 150 μm |
| Return Loss | ≥ 60 dB |
| Attenuation Splicing | Yes |
| Splicing Method | Core Alignment |
| Battery Life | 200 splice/heat cycles |
| Display | LCD |
| Applicable Fibers | SM, MM, DS, NZDS |
| Coating Diameter | 100 - 1, 000 μm |
| Typical Splice Loss | 0.02 dB (SM), 0.01 dB (MM) |
| Arc Calibration Method | Automatic |
| Splice Loss Estimate | Yes |
| Heater | Built-in heater |
| Applicable Protection Sleeve | 40-60 mm |
| Power Supply | AC adapter or battery |
| Terminals | USB |
| Operating Condition | -10°C to 50°C, 0-95% RH (non-condensing) |
| Fiber Cleave Length | 8-16 mm |
| Storage Condition | 0-95% RH (non-condensing) |
Guides on fiber preparation, cleaving with CT50, and using fiber holders.
Explains fusing power calibration, the splicing procedure, and loss analysis.
Explains cleaver blade repositioning and periodic inspection/cleaning routines.
Guides on selecting, changing, editing, creating, and deleting splice modes.
Procedure for calibrating fusing power and interpreting calibration results.
Details diagnostic tests, dust checks, and motor calibration for performance.
Lists and explains errors related to fiber length, dust, position, and fusing process.
Explains errors related to fusing, cleave angle, fiber angle, and dust.
Addresses problems with power supply, battery, and inconsistent splice loss.
Covers sleeve heating, wireless communication failures, and supervising functions.
