En-3
3. AIRFLOW SETTINGS
NOTE:
For detailed instructions on how to operate, refer to the
operation manual of the remote controller.
3.1. Fan speed setting
The fan speed can be selected from the followings.
Fan speed Description
Auto
The fan speed is automatically adjusted according to
the operation mode.
Cooling : As the room temperature approaches the
set temperature, the fan speed becomes
lower.
Heating : The fan will operate at a very low speed
when the temperature of the air issued
from the indoor unit is low.
Fan : The fan runs at Med speed.
High The indoor unit fan rotates at a high speed.
Med The indoor unit fan rotates at a middle speed.
Low The indoor unit fan rotates at a low speed.
Quiet
*
The indoor unit fan rotates at the lowest speed for
Quiet operation.
● The Quiet operation cannot be used during
the Dry mode. (It includes the Dry mode selected
during the Auto mode operation.)
● During the Quiet operation, heating and
cooling performance will be reduced somewhat. If
the room does not warm up/ cool down when using
the Super Quiet operation, adjust the indoor unit’s
fan speed.
*This function is available for ARTH60KHTB.
The fan will operate at a very low setting during monitor operation and
at the start of the heating mode.
4. TIMER OPERATIONS
NOTE:
For detailed instructions on how to operate, refer to the operation
manual of the remote controller.
4.1. On timer or Off timer
The On timer starts the operation at your desired time.
The Off timer stops the operation at your desired time.
4.2. Weekly timer
NOTE:
Depending on the remote controller, this function may not be
available.
The Weekly timer enables you to set operation schedules for each day
of the week.
Use the Day off setting to switch off timed operation for a selected day
in the coming week. Because all days can be set together, the weekly
timer can be used to repeat the timer settings for all of the days.
Temperature setting range
Auto, Cooling, or
Dry mode:
18.0-30.0 °C
*Even if you set to 16.0 to 17.5 °C, the air
conditioner will run at 18.0 °C.
Heating mode: 16.0 to 30.0 °C
4.3. Program timer
NOTE:
This function is available only when using the wireless remote
controller.
The Program timer operates as the combination of the On timer and Off timer.
You can set the Program timer only within a span of 24 hours.
Dry mode
Use for gently cooling while dehumidifying your room.
NOTES:
• You cannot heat the room.
• Set the temperature lower than the current room temperature,
otherwise, the operation will not operate.
• The unit will operate at low speed in order to adjust room humidity.
The indoor unit’s fan may stop from time to time. Also, the fan may
operate at a very low speed when adjusting room humidity.
• The fan speed cannot be changed manually.
Fan mode
Use to circulate the air throughout your room.
NOTE:
You cannot set the temperature.
Heating mode
Use to warm your room.
NOTES:
• Set the temperature higher than the current room temperature,
otherwise, the operation will not operate.
• At the beginning of the operation, the indoor unit fan rotates at a
very low speed for 3-5 minutes to warm the internal indoor unit. After
the period, the indoor unit fan will switch to the selected fan speed.
• When the room temperature is very low, frost may form on the
outdoor unit, and its performance may be reduced. In order to
remove such frost, the unit will automatically enter the defrost
cycle from time to time. During Automatic defrosting operation, the
Heating operation will be interrupted.
• After the start of the Heating operation, it takes sometime before the
room gets warmer.
draft059381067299-01[base9381067237-02OMEN].indd3draft059381067299-01[base9381067237-02OMEN].indd3 2022/10/208:52:322022/10/208:52:32
To Next Page
Loading...
