Fujitsu Airstage ASUB24TLAV1 - 3 Adaptor; Convertor Units; Network Convertor; Modbus Convertor for Vrf

3. ADAPTOR / CONVERTOR UNITS
The following types of convertors and adaptors are available.
•
Network Convertor (UTY-VTGX)
For connecting single split type system.
•
Network Convertor (UTY-VGGXZ1)
For connecting single split type system.
( A change of DIP switch setting is necessary )
•
Modbus
®
Convertor for VRF (UTY-VMGX)
For connection between VRF network system and a Modbus
®
open network.
•
Network Convertor for L
ON
W
ORKS
®
(UTY-VLGX)
For connection between VRF network system and a L
ON
W
ORKS
®
open network for
management of small to medium-sized BMS.
•
Thermostat Convertor (UTY-TTRX)
For control Fujitsu General products using a third-party thermostat controller.
•
BACnet
®
Gateway (UTY-VBGX : Hardware)
For connection between VRF network system to the BMS system using BACnet
®
protocol.
•
BACnet
®
Gateway (UTY-ABGXZ1, UTY-ABGX : Software)
The central control of maximum 1,600 indoor units can be realized by connecting the VRF
network system to the BACnet
®
, a global standard for open networks.
•
Signal Amplier (UTY-VSGXZ1)
When the total length of transmission line exceeds 1640ft. (500m) or the number of units
exceeds 64, Signal amplier will be necessary.
•
External Switch Controller (UTY-TERX, UTY-TEKX)
Air conditioner switching can be controlled by connecting other sensor switches.
- (05 - 116) -
CONTROL SYSTEM CONTROL SYSTEM