Fujitsu AIRSTAGE - Basic Operations; Operation Modes and Temperature Settings; Auto Mode Functionality

En-2
CAUTION
• Do not direct the airow at replaces or heating apparatus.
• Do not block or cover the outlet port and air intake grille.
• Do not apply any heavy pressure to radiator ns.
• Do not climb on, place objects on, or hang objects
from this product.
• Do not place any other electrical products or
household belongings under this product. Dripping
condensation from this product might get them wet,
and may cause damage or malfunction of your
property.
• Do not expose this product directly to water.
• Do not use this product for preservation of food, plants,
animals, precision equipment, art work, or other objects.
This may cause quality deterioration of those items.
• Do not expose animals or plants to the direct airow.
• Do not drink the drainage from the air conditioner.
• Do not touch the aluminum ns of heat exchanger
built-in this product to avoid personal injury when you
maintain the unit.
• Do not stand on unstable steps when operating or
cleaning this product. It may overturn and can cause
injury.
This product contains uorinated greenhouse gases.
2. NAME OF PARTS
The remote controller is optional. You can select from the
following types of remote control.
- Wireless remote controller
- Wired remote controller
- Wireless LAN control
To check the available model of remote controller, consult authorized
service personnel.
For detailed instructions on how to operate, refer to the
operation manual of the remote controller.
Horizontal louvers
Vertical louvers*
(behind the horizontal louvers)
• Intake grille
• Air lter (in the intake grille)
* The number and positions of the vertical louvers di󰀨er by the model.
3. BASIC OPERATIONS
NOTE: For detailed instructions on how to operate, refer to the
operation manual of the remote controller.
The operation mode and the temperature setting range are
shown in the following table.
Operation mode Temperature setting range
Auto/Cooling/Dry 64-88°F (18.0-30.0°C)
Fan You cannot set the temperature.
Heating 60-88°F (16.0-30.0°C)
■
Auto mode
The air conditioner selects the appropriate operation mode
(Cooling or Heating) according to your room’s present
temperature.
Room temperature Operation
Higher than the setting temperature Cooling
Close to the setting temperature Monitor operation
Lower than the setting temperature Heating
Set temperature
Monitor operation
Cooling mode
Heating mode
When Auto mode is rst selected, the fan will operate at low speed for
about a few minutes, during which time the indoor unit detects the room
conditions and selects the operation mode.
When the air conditioner has adjusted your room’s temperature to near
the thermostat setting, it will begin monitor operation.
In the monitor operation mode, the fan will operate at low speed. If the
room temperature subsequently changes, the air conditioner will once
again select the appropriate operation (Heating, Cooling) to adjust the
temperature to the value set in the thermostat.
If the mode automatically selected by the unit is not what you wish,
select one of the mode operation (Heating, Cooling, Dry, Fan).
■
Cooling mode
Use to cool your room.
NOTES:
• Set the temperature lower than the current room temperature,
otherwise, the fan alone will operate.
• The indoor unit fan may stop from time to time to perform Fan
control for energy saving that enables power-saving operation by
stopping the rotation of the indoor unit fan when the outdoor unit is
stopped.
In initial setting, this function is activated.
To deactivate the function, refer to the operation manual of the
remote controller or consult the authorized service personnel.
■
Dry mode
Use for gently cooling while dehumidifying your room.
NOTES:
• You cannot heat the room.
• Set the temperature lower than the current room temperature,
otherwise, the operation will not operate.
• The unit will operate at low speed in order to adjust room humidity.
The indoor unit’s fan may stop from time to time. Also, the fan may
operate at very low speed when adjusting room humidity.
• The fan speed cannot be changed manually.
9384329042-01_OM.indb 2 22-Dec-22 17:18:48